If you want to learn more about bobcat 773 turbo problems, this website will help you with the details. The mechanic describes the main problems of this equipment and gives solutions that help the owners to fix their own machines.
Some Common Bobcat 773 Turbo Problems
Bobcat 773 turbo skid steer loader is equipped with a universal skid steer quick hitch. This will allow a wide array of attachments to be used on the front of the vehicle. The Bobcat 773 turbo has a 74 hp turbocharged fuel-injected engine and has an operating capacity of 2700 pounds and can lift up to 1600 pounds. This model was first introduced in 1996.
There are many common problems that occur with the Bobcat 773 turbo. One common problem is leaking hydraulic fluid from the front of the loader arms. This is due to loose or worn out seals on the hydraulic cylinders on either side of the bucket. Another common problem with the Bobcat 773 is intermittent steering or complete loss of steering control. This can be caused by low fluid levels, dirty fluid, faulty hydraulic lines, low battery charge, and faulty hydraulic pumps.
A third common problem with the Bobcat 773 turbo is sluggish operation under load. The cause of this problem can range from air in the hydraulic system to dirty filters, low engine oil level, or plugged fuel injectors. The fourth problem that commonly occurs with this machine is a rough idle when it’s first started. The cause of this could be an air leak at one of the manifold hoses
Bobcat 773 turbo constantly overheats
The bobcat 773 is a diesel engine. And it does not like to run at higher temps, it will burn up and die. They are heat sensitive. That sounds like a bad thermostat, but if you are replacing it with the same one, then you need to replace it with a lower temp t-stat, or the same one with a new seal on it. The old seal may be allowing water to bypass the t-stat.
The other thing that will cause overheating is the coolant level being too low. If your coolant level is low then you might want to check for leaks, as well as looking into your radiator cap. A bad cap can cause overheating when the coolant level is low because of the vacuum that builds up in the cooling system, and if the cap does not have enough vacuum relief pressure then your cooling system will fail to work properly.
Bobcat 773 turbo won’t start or has no power
The problem with the Bobcat 773 turbo skid steer is, it won’t start. It does not start up at all. The battery is fine and the alternator is fine too. The starter works, but it will not turn over the engine. Maybe it does start, but lacks power or runs rough, and then stalls out or shuts down completely.
The fuel pump in this Bobcat 773 is bad and needs to be replaced. This particular pump was located on top of the fuel tank. It’s a very common problem for this type of machine to have a faulty fuel pump.
If you’re having any trouble with your skid steer, contact me and I can probably help you out!
Stalling problems with Bobcat 773 turbo
I have this Bobcat for about a year now and it has been sitting for about 6 months. I got it to start, but as soon as I put it in gear and give it gas, the engine stalls. It only has 400 hours on it. I did not do anything to the fuel system; just drained and filled fresh fuel. I replaced all of the fluids and filters and put new spark plugs. It does not smoke at all when it runs, so I don’t think it’s the injectors, but who knows? Also, if I keep the engine running by pumping the throttle, there is no bucking or surging, so I don’t think it’s electrical. Any ideas of what to look for?
How to Fix Turbocharger of Bobcat 773?
The turbocharger of Bobcat 773 is the part that is responsible for the efficiency of the unit. The turbo charger is a small thing but it contains a lot of power and has to be looked after. How to fix Turbocharger of Bobcat 773?
The first thing that you have to do is to remove the old turbocharger from the engine and then check if there are any leaks in the system. If you find any leaks, you should immediately clean it up. You should also check if there are any cracks or damages on the housing of the turbo charger and if so, you should replace them as well. Then, you should install the new turbocharger back into the engine.
You can also fix Turbocharger of Bobcat 773 by yourself if you follow some simple steps. The first thing that you have to do is to remove the old turbocharger from the engine and then check if there are any leaks in the system. If you find any leaks, you should immediately clean it up. You should also check if there are any cracks or damages on the housing of the turbo charger and if so, you should replace them as well. Then, you should install the new turbocharger back into the engine.
A few common bobcat 773 problems can be fixed at home, while others may require professional help
A few common bobcat 773 problems can be fixed at home, while others may require professional help. If the engine does not start or if it runs poorly, the first thing to do is check the fuel and air filters. Dirty filters restrict airflow and reduce engine performance, causing a variety of problems. The air filter should be replaced every 200 hours. The fuel filter should be replaced every 500 hours. These are both easy maintenance tasks that can prevent a lot of other problems from occurring.
If you clean or replace the air filter or fuel filter and your Bobcat still will not start or runs poorly, remove the spark plug and check for damage or carbon deposits on it. It is also a good idea to check the spark plug gap with a wire feeler gauge to make sure the proper gap is maintained between the center electrode and the side electrode.
The fuel solenoid delivers fuel to the injector pump, but sometimes they become worn out over time and need to be replaced. You can test your solenoid by removing one of the wires from it and checking it for continuity with an ohmmeter on resistance scale (R x 100).